The mid-handle grip is the point. On a pistol-grip drill the handle sits behind the motor, so the tool wants to nose down and you're fighting it on every hole. Move the grip to the middle and the weight balances over your hand — the drill sits level, stays where you point it, and stops wearing out your wrist.

That balance matters most exactly where drilling is hardest: overhead, at arm's length, in awkward positions, or through long runs of repetitive holes. Anyone who has spent a shift drilling into a ceiling grid or reaching into a machine understands the difference immediately.

Eight amps at 0–2,500 RPM is the most motor in DeWalt's 3/8" corded line — a full amp over the pistol-grip DWD110K and DWD112. Handles 1" spade bits and 1-1/8" hole saws in wood, 3/8" twist bits in steel.

The 3/8" all-metal ratcheting chuck is where budget drills fail. Polymer chuck bodies crack when a bit binds and lose grip on smooth shanks long before the motor quits. This one holds tighter and outlasts the tool.

All ball-bearing construction throughout is the other reason these last — bushings wear, bearings don't. At 12-3/4" overall and 4.1 lbs it's longer than a pistol-grip drill but carries better, and the soft anti-slip grip gives you real purchase.

Suits millwrights, maintenance techs, fabricators, electricians, and anyone whose drilling happens in positions a pistol grip fights.